Schneider VX4A61100Y Control Board Kit – ATV61 Frame 1–9 Original Pulled

When This Board Is the Suspect

The control board becomes the replacement target when CPU-level symptoms persist after supply and wiring checks:

• InF4 (Internal Error 4) — incoherent internal data. Schneider lists control block replacement as a resolution path. Recalibration may be attempted first where support is available.
• No display / dead panel with power confirmed present — the drive receives supply but shows no indication. A CPU board fault can produce this.
• Persistent communication loss — the drive does not respond on its communication port, with cabling and settings verified.

Compatibility Check

Before ordering, confirm:

• Drive series — must be ATV61, not ATV71. ATV71 uses VX4A71100Y.
• Frame size — must be Frame 1–9. Frame 10–16 uses VX4A61101Y, which is not interchangeable.
• Original board marking — confirm the existing board reads VX4A61100Y.
• If unsure, send a photo of the original board label and the drive nameplate before purchase.

FAQ

Is VX4A61100Y the same as VX4A61101Y?

No. VX4A61100Y is for ATV61 Frame 1–9. VX4A61101Y is for Frame 10–16. They are not interchangeable.

What does “Original Pulled” mean for this board?

It is a clean pull from a decommissioned drive, supplied as-is without repair or refurbishment. It is not a new original or a tested/refurbished unit. Confirm this condition meets your maintenance requirements before ordering.

Will the replacement board come with the correct firmware for my drive?

Not guaranteed. ATV61/71 firmware cannot be upgraded in the field. The replacement board’s firmware level may differ from the original. Confirm with the supplier before installation.

Condition & Dispatch

Original Pulled — clean pull from decommissioned equipment, not refurbished or repaired. Inspection covers connector condition and PCB appearance. Photographic records are available on request before dispatch.